ht 150 SCD

For determining seal strength as per EN 868-5:2009 AND ASTM F88.

The Performance Qualification (PQ) carried out as part of the initial validation and for revalidation requires determination of the seal strength. Seal samples can be created precisely at the required width of 15 mm using the integrated sample cutter (ht 150 SCD). These are then clamped into the testing machine and peeled at a monitored speed of 200 mm/min. The strength curve is recorded. The supplied software is used to draw up test reports.

Technical Data:

  • Report of the tested seal seam tensile strength on the display
  • Menu guided device operation by keyboard
  • Storage of 10 measurement values
  • PC software and check weight for routine calibration included
  • Aluminium transport box